N55 Valve Cover Torque Sequence

Observe Sequence For Tightening Cylinder Head Bolts Without Fail.

Lbs (n.m) a/c compressor bolt 18 (24). Nonresusable fasteners torque specifcations project time: I am not responsible for any damage done to your car following this tutorial.

Need Torque Specs And Tightening Sequence.328I Xdrive 2012.

So you will be removing the intake manifold. Worked perfectly for mine so it should for yours as well. Haven't figured out the torque specs 2012 bmw 535i n55.

R Bmw N54 Valve Cover Gasket Replacement Ecs Tuning 1000 Seville Rd.

I torqued the original bolts back down in a z pattern to make sure the valve cover was torque evenly on the cylinder head. Must be 30% less than shown in the table. Mine was leaking recently so i decided to replace it and document the process along the way.

The N55 Also Followed The N54'S Footsteps Winning 3 Straight Ward's 10 Best Engines Awards.

Bmw n55 valve cover replacement torque specs: Bolt torque specs for n55 engine. Tightening torque 11 12 2az.

Valve Cover Bolt/Stud Bolt 79 (9) Valve Tappet Guide Plate Retainer Bolt 79 (9) Wire Harness Bolt 89 (10) (1) Tighten In Sequence.

Bmw's tis manual recommends 9nm or torque on the valve cover bolts. So you need torque specs for valve cover gasket, oil filter housing, and oil cooler lines? Hey all, i have seen a lot of valve cover gasket diy from older e90 n54 cars, but i couldn't find anything complete for our f30 generation n55 motors.